RADtec H1501A, Инструкция по эксплуатации

Страница: 10 / 16

- -
OPERATING INSTRUCTIONS
EFORE FIRST USE AND AFTER E ERY GAS CYLINDER CHANGE THE GAS DELI ERY SYSTEM MUST
E PURGED OF AIR EFORE IGNITING! TO DO THIS TURN THE CONTROL KNO COUNTER CLOCKWISE
TO THE PILOT SETTING PRESS KNO IN AND HOLD FOR MINUTES EFORE ATTEMPTING IGNITION
ATTERY REPLACMENT
Remove impulse ignition cap from urner Assembly ( ) by turning cap counterclockwise. Install 1 AAA battery.
Negative end of battery goes in first, then replace impulse ignition cap by turning cap clockwise.
TO LIGHT THE PILOT
• Check all connections prior to each use.
• Turn on main gas supply at source.
• Press to turn control knob counter-clockwise to
PILOT , see photo on the right.
• Push the control knob in, while simultaneously
pressing the IGNITION button repeatedly until the
pilot flame is lit. Continue to depress the control
knob for at least 10 seconds to assure the pilot
remains lit after releasing the knob.
• If the pilot fails to ignite, press the knob clockwise
to
OFF and repeat.
TO LIGHT THE PATIO HEATER
• The pilot should be lit and the knob set to PILOT .
• Hold the knob in gently and turn counter-clockwise to LOW .
• After the glass has warmed up 1-5 minutes, turn knob clockwise from Low to HIGH as needed.
Note: The burner may be noisy when initially turned on. To eliminate excessive noise from the burner turn
the control nob to the ilot osition. Then turn the nob to the level of heat desired.
RE LIGHTING
• Turn Control nob to OFF.
• Wait at least 5 minutes, to let gas dissipate, before attempting to re-light pilot.
• Repeat the Lighting steps.
TO E TINGUISH
• Hold the knob in and turn the knob clockwise to OFF
• Close the valve of the gas cylinder or the regulator after use.
• Close the gas bottle and allow the appliance to cool before moving.
Note: After use some discoloration of the emitter screen is normal. Close re ulator after use allow the
a
liance to cool before movin .