
18
5073-357
Remove the discharged battery pack (1) from the tool by pressing the battery
release button (2) on the rear of the battery downward (Fig. 3) and pulling the
battery pack out of the tool handle (3) (Fig. 4).
Insert the fully charged battery pack into the matching slots in the rear of the
tool handle where the discharged battery pack has been removed.
NOTE:
The battery release button will “click” into place when the battery pack
is fully installed.
INSTALLING THE BATTERY PACK IN THE GRASS TRIMMER
1.
2.
Place the tool on its back on a clean work surface (Fig. 5).
Slide the guard in the direction as indicated by the arrow (2).
NOTE:
Make sure the trimmer line (3) is not trapped between the guard mount
and the guard.
Install 1 screw (4) into the matching holes (5) in the motor housing.
Tighten screw using a #2 Screwdriver.
NOTE:
Do not over tighten the screws. You will strip the threads in the motor
housing.
1.
2.
3.
4.
INSTALLING THE GUARD
WARNING: Do not immerse battery pack in water. Sudden cooling could cause
a hot battery to explode or leak.
WARNING: The guard must be installed before installing the battery pack in
the tool. Serious injury may result if the tool is turned ON without the guard in place.
Fig. 3
Fig. 4
Fig. 5
6