5044-032
16
1600PSI PRESSURE WASHER
I can’t remove the lance from
the spray gun. What should I
do?
All lances and detergent tank are attached and
removed from the spray gun in the same manner.
Insert the quick-release end of the lance togeth
-
er (about a1/8”/3.175 mm) and turn clockwise.
The lance will lock in place. Remove the lance by
reversing this procedure. Press the spray gun and
lance together and turn counterclockwise. The
lance will slide out. Or, hold the spray gun and
lance in an upright position with the nozzie end on
the floor.Push the whole assembly straight down
to loosen the connection, and then follow the
removal process again. You may also spray soapy
water or a lubricant in the area where the lance
connects to the spray gun.
The power washer turns on for
2 seconds, shuts off, and will
not turn back on. Do I have a
defective unit?
It sounds like your power washer is working just
fine. When the water is connected, the accessories
are assembled properly, and the power switch
is turned on, the power washer may turn on for
1-2 seconds to prime the pump. It automatically
shuts off and waits for the spray gun trigger to be
pressed. When the trigger is pressed, water starts
flowing through the pump. The water sensor in the
pump “sense” the moving water and automatically
turns the power washer on. Or the power switch
to off, hold in the trigger on the spray gun, so that
you have a steady stream of water. While you are
holding the trigger open on the spray gun, at the
same time, turn the power switch on.
