7
the dust collected in the vacuum.
Do not continue to use a worn, torn or clogged sanding belt. The sanded surface will be
rough and the motor will become overloaded.
EXTENSION CORD SAFETY
Make sure your extension cord is the proper size.
When using an extension
cord, be sure to use one heavy enough to carry the current the tool will draw.
An undersized cord will cause a drop in line voltage resulting in loss of power
and overheating. The table on at right shows the correct size to use according
to cord length and nameplate ampere rating. If in doubt, use the next heavier
gauge. The smaller the gauge number the heavier the cord.
Be sure your extension cord is properly wired and in good condition.
Always
replace a damaged extension cord or have it repaired by a qualified electrician
before using it. Protect your extension cord from sharp objects, excessive heat
and damp or wet areas.
Use a separate electrical circuit for your power tools.
This circuit must not be less than 14 gauge wire and should be protected with
either a 15A time delay fuse or circuit breaker. Before connecting the power
tool to the power source, make sure the switch is in the OFF position and the
power source is the same as indicated on the nameplate. Running at lower
voltage will damage the motor.
WARNING:
Repair or replace damaged or worn extension cords immediately.
Select the appropriate extension cord gauge
and length using the chart
to the below.
When operating a power tool outdoors, use an outdoor extension cord
marked “W-A” or “W”.
These cords are rated for outdoor use and reduce the
risk of electric shock.
WARNING:
Keep the extension cord clear of the working area. Position the cord so it will
not get caught on the workpiece, tools or any other obstructions while you are
working with the power tool.
MINIMUM GAUGE (AWG)
Amperage rating
Total length
More
than
Not more
than
25' (7.5 m)
50' (15 m)
100' (30 m)
150' (45m)
0
6
18
16
16
14
6
10
18
16
14
12
10
12
16
16
14
12
12
16
14
12
Not Applicable
Содержание 1262-801
Страница 1: ...JD3764U 3042597 7 5A 3 X 21 BELT SANDER OWNER S MANUAL 3 Year Limited Warranty on tool...
Страница 22: ...21...
Страница 23: ...1262 801 7 5A 3 X 21 BELT SANDER 22...
