RADLEY 1262-801, Руководство пользователя

Страница: 13 / 24

1262-801
7.5A 3 X 21" BELT SANDER
12
NOTE:
The hinged front sanding belt cover may be lifted up for easier access to the front roller.
2. Slide the sanding belt (3) off the rear roller (4) and the front roller (5).
3. To install a new sanding belt, slide the new sanding belt over the rear and front rollers.
NOTES:
a) Make sure the rotation arrow (6) inside the bottom of the sanding belt is pointing
toward the rear of the tool.
b) Make sure the sanding belt is centred on the rear and front rollers.4. Push the tension
release lever back into the side of the sanding belt carrier.
4. Squeeze the ON/OFF trigger switch momentarily and check to make sure the sanding
belt is centred on the rear and front rollers. If the sanding belt is not centred on the
rollers, adjust the sanding belt tracking as outlined in the following section.
ADJUSTING THE SANDING BELT TRACKING
If the sanding belt does not run in the centre of the sanding belt rollers, the sanding belt
tracking adjustment knob must be used to correct the sanding belt alignment.
1. Turn the sander up-side down. Make sure the sanding belt is NOT touching anything.
Set speed to #1.
2. Turn the sander switch ON and let the tool run for a few seconds.
3. While the sanding belt is turning, turn the tracking adjustment knob (1) very slightly
and observe how the sanding belt moves on the sanding belt rollers (2) (Fig. 6).
2
2
1
Fig. 6
NOTES:
a) Make very small adjustments and let the tool run for a few seconds after each
adjustment to allow the sanding belt to move to its new tracking position
on the rollers.
b) Turn the tracking adjustment knob clockwise to make the belt move toward the
tracking knob. Turn the tracking adjustment knob counter clockwise to make the
sanding belt move away from the tracking adjustment knob.
c) Continue to make SMALL adjustments until the sanding belt is tracking in the centre
of the rollers before using the sander on the workpiece.