RADLEY 1240-055, Руководство пользователя

Страница: 14 / 22

13
3 /
8
" Drill - Owner's Manual
INSTALLING DRILL BITS – cont’d
4. Finish tightening the chuck jaws by
holding the chuck collar with one
hand and firmly tightening the chuck
body by rotating it in a clockwise
direction.
NOTE:
Hand tighten the chuck jaws.
Do NOT use pliers
WARNING: Do not insert the drill bit into
the chuck and tighten as shown in Fig. 4.
The drill bit MUST be properly inserted
with all three of the chuck jaws holding
the bit centered in the chuck. Failure to
properly insert the drill bit could cause
the drill bit to be thrown from the chuck,
resulting in possible serious injury or
damage to the chuck.
REMOVING DRILL BITS
1. To open the keyless drill chuck, grasp
and hold the chuck collar with one
hand. Rotate the chuck body in a
counter-clockwise direction until
the chuck jaws open wide enough to
release the bit.
2. Remove the bit.
TRIGGER SWITCH LOCK
The trigger switch lock-on feature allows
the trigger switch to be locked in the ON
position at full speed when continuous
operation for extended periods of time is
required (Fig. 5).
To lock the trigger switch in the ON
position, pull back on the trigger switch
to start the drill. Continue to squeeze the
trigger until the drill reaches its maximum
speed. Push the trigger switch lock button
(3) into the drill handle. Release the trigger
switch while holding the trigger switch
lock button into the drill handle. The
drill will continue to run at full speed. To
release the trigger switch lock button, pull
the trigger switch back and then release
the trigger.
ASSEMBLY AND OPERATING
(continued)
Fig. 3
Fig. 4
Fig. 5