RADLEY 1240-055, Руководство пользователя

Страница: 13 / 22

12
1240-055
FORWARD/REVERSE SWITCH
The forward/reverse switch (1) is
conveniently mounted above the trigger
switch (2) (Fig. 1). To make the drill rotate
clockwise for drilling, push the forward/
reverse switch to the right. To make the
drill rotate counter-clockwise, push the
forward/reverse switch to the left.
NOTES:
a) Never change the position of the
forward/reverse switch while the chuck is
turning.
b) There is no dead center position for the
forward/reverse switch. The tool will run
only when it is in either the full left or full
right position.
VARIABLE-SPEED TRIGGER SWITCH
This drill is equipped with a variable-
speed ON/OFF trigger switch.
1. To start drill, gently squeeze the
trigger switch (2) (Fig. 2).
NOTE: The drill will turn at its slowest
speed when the trigger switch is
depressed slightly. The drill will turn
at its fastest speed when the trigger
switch is fully depressed.
2. To stop the drill, release the trigger switch.
NOTE:
Drilling at a slow speed for an
extended period of time may cause
the drill motor to overheat. If drill
gets hot, stop drilling and allow it to
cool for at least 15 minutes.
INSTALLING DRILL BITS
WARNING: Never hold the chuck body
with one hand and use the drill power to
rotate the drill body to loosen or tighten
bits. Serious injury may result
This drill is equipped with a keyless chuck.
This chuck is designed to provide easy
two-handed tightening and loosening of
the chuck jaws.
1. To open the keyless drill chuck, grasp
and hold the chuck collar (1) with one
hand (Fig. 3). Rotate the chuck body
(2) in a counter-clockwise direction
until the chuck jaws (3) open wide
enough to accept the bit (4).
2. Insert the bit into the chuck the full
length of the jaws or until the spiral
portion of the bit is near the chuck
jaws. Raise the front of your drill
slightly to prevent the bit from falling
out of the chuck jaws.
3. Tighten the chuck jaws onto the
bit by turning the chuck body in a
clockwise direction.
NOTE:
Make sure the bit is properly
aligned in the jaws and NOT at an
angle. An improperly aligned bit
could be thrown from the chuck
when the drill is started
ASSEMBLY AND OPERATING
Fig. 1
Fig. 2