RadiSwitch
®
Quick Start Guide
RadiSwitch
®
Quick Start Guide
How to check if the RadiSwitch® is connected to RadiMation
In order to utilize the RadiMation® software to its fullest capabilities ensure that
the latest RadiMation® software version is installed. Additionally, confirm that all
equipment is correctly connected and turned ON.
Important information
When you need support with the configuration of your Radi-Product in RadiMation®, please consult the RadiMation
®
support team
at:
.
It is also advised to visit the RadiMation
®
Wiki page and the FAQ section, which can be found at:
https://wiki.radimation.com
RadiMation
® software can be downloaded at:
https://www.raditeq.com/emc-test-software/radimation-download
1
3
2
4
1. Select ‘Devices’ in the top menu bar
2. Open ‘Device Drivers’ and select device driver type: ‘Switch Matrix’
3. Double Click the recently configured RadiSwitch® or click ‘edit’.
4. Finally select the ‘check’ button on the right side of the opened screen.
5. When correctly configured RadiMation® will notify you that the device was installed correctly.
Please keep this Quick Start Guide close at hand when you operate your Raditeq equipment and instruments. For more information,
please consult your product manual or visit www.raditeq.com Be advised that visuals used as an example and may differ from your
product version. Copyright © 2008 – 2021 Raditeq B.V.
This product contains embedded software, which is field upgradeable from the RadiCentre® using the USB-A
connection port on the backside panel of the RadiCentre®. For more information about updating your Raditeq plug-
in card, please read the RadiCentre® manual.
Read the contents of this product manual carefully and become familiar with the safety markings, the product
instructions and the handling of the system. Please refer to the applicable product manual(s) for further information
regarding the operation and control of the product(s).
This product contains no hazardous substances as described in the RoHS Directive (2015/863/EU).
This equipment is designed to be used as a plug-in card for the RadiCentre
®
series. Do not use this card on its own
or in combination with any other mainframe. Using this product with any other mainframe can cause harm and will
void warranty.
Only Raditeq qualified maintenance personnel is allowed to perform maintenance and/or repair service on the
equipment.
This product requires a protective earth connection. The mains power source for the equipment must supply an
uninterrupted safety ground to the IEC input connector(s).
To increase the safety of immunity test systems, some of our RadiSwitch cards are equipped with an additional
interlock function, which is designed to work with our modular RadiCentre® systems.
