Pacific Accessory Corporation
®
| Ph. 866-931-8021 | [email protected]
©2015 Pacific Accessory Corporation
www.pac-audio.com
Pacific Accessory Corporation
RP4.2-HY12
Radio Replacement &
Steering Wheel Control Interface
for Hyundai Veloster
Rev. 101515
Page 6
RadioPRO App
Use of the RadioPRO App in Hyundai allows you to do the following:
• Configure User Interface Options such as:
• Red/White wire output behavior
• Aftermarket radio Parking Brake Sequencing
• Factory amplifier settings (Bass, Mid, Treble, Gain, Fader & Balance)
• Update Product Firmware
• Read Firmware/Hardware Versions
• Access Product User Manuals
Programmable Red/White Wire
The red/white wire can be programmed to do a pulsed or latched trigger that is controlled by a user assigned steering wheel
control button, or it can be set to provide an output when triggered by the vehicles foot brake, door or trunk. Select User
Interface Options then set the behavior of the red/white wire using the drop down menu. PLEASE NOTE: Available triggers
depend on what info is available on the vehicles data bus. Restoring factory settings on the module will default this wires output
back to a latched SWC trigger.
Trunk -
This selection will provide a 12v+ output on the red/white wire whenever the HS-CAN is active and the trunk is opened.
Alpine -
If you select the “Alpine” setting on the drop down menu, the red/white wire will then work in conjunction with the
parking brake output to produce the necessary sequencing for settings menu access. This sequencing is based on the actual
parking brake, meaning to produce this sequence you have to engage the parking brake in the vehicle. If you would like to
manuallly do the necessary foot brake/parking brake sequencing for Alpine, select the “Foot Brake” setting (if available) and the
red/white wire will output a 12v+ signal whenever the HS-CAN is active and the foot brake is pressed.
Door -
This selection will provide a 12v+ output on the red/white wire whenever the HS-CAN is active and any door on the
vehicle is opened.
Footbrake -
This selection will provide a 12v+ output on the red/white wire whenever the HS-CAN is active and the foot brake is
pressed.
PLEASE NOTE:
Sonata Hybrid will not provide a foot brake output even though it is displayed in the app.
Latched -
This selection will provide a latched 12v+ output that can be tied to any of the vehicles SWC. This means that when
you press the assigned SWC, the red/white wire will turn on and remain on until the assigned SWC is pressed again or the
ignition is turned off.
