RadioPopper P1, Руководство пользователя

Страница: 5 / 30

How It Works
Your current master and slave wireless flash system continues to
function just as it always has. That’s the beauty and simplicity of the
RadioPopper P1 system.
The RadioPopper P1 Transmitter “listens” to the light signal being
created inside the master flash unit or remote commander on your
camera’s hot shoe. The P1 Transmitter sends this signal over the radio
where it is read by the RadioPopper P1 Receiver. The receiver then uses
it’s own internal light source to “reproduce” this light signal. The light
is sent down the flexible fiber optic cable where it lights a small nylon
bead at the end. When this bead is placed over the infrared sensor on
a slave flash - that slave flash responds to the “reproduced” light signal
just as it normally would had it seen the light directly from the master
flash.
Installation couldn’t be more simple. Just place the RadioPopper P1
Transmitter on top of your master flash or IR commander device using
the included Velcro pads. “Look Ma! No wires!”
On the receiving end, add a P1 Receiver in a similar way, anchor the
optic bead over the infrared sensor on your slave flash and you’re all
done. No wires or adaptors and no complicated system to re-learn.
Now just power up and shoot. You’ve got remote control of your slave
flashes, full ETTL and iTTL support along with high speed sync all the
way to 1/8000 - by radio.
NOTE:
When first using the system you may develop “smile ache” in
your cheeks, and you may feel the uncontrollable urge to giggle like a
school girl. This is perfectly normal.
Introduction
Page 5