RadioPopper P1, Руководство пользователя

Страница: 17 / 30

Operation: Detailed P1 Transmitter Operating Instructions
Power On / Off
Press and hold the Power Button for approx one second to alternate between Power On and Power Off.
Radio Link & Broadcast
The RadioPopper P1 Transmitter has been designed to conserve power, to automatically stop broadcasting when not
in use, and to allow several photographers to “share” a single radio signal through a system of easily turning the radio
transmitter on and off without fully powering down the entire unit.
1) When power is first turned on, the Link LED lights indicating the radio is broadcasting. The Link LED is always lit
whenever the radio is broadcasting, and is dark whenever the radio is not broadcasting.
2) When in an environment with multiple photographers, only one P1 Transmitter may be broadcasting at any given
time within the same general area.
Manually Sleeping the Radio
To temporarily deactivate the radio and stop broadcasting (either to save power or to allow another photographer to
activate their own transmitter and control the same set of slave flashes) - simple press and hold the Link Button for
one second to turn off the Link LED. The radio is now sleeping and will not resume broadcasting until the Link LED is
pressed again. To wake the radio and resume broadcasting, tap the Link Button one time. The Link LED should light
indicating the radio is again broadcasting.
Automatic Radio Sleep
The P1 Transmitter will automatically stop broadcasting and go into sleep mode if there are no shots taken, or if the
Link Button is not pressed for about seven minutes. This feature insures the radio frequency will be clear for another
photographer or assistant to use if the first unit becomes inactive. It also dramatically reduces power consumption if
an active transmitter is forgotten about. This automatic sleep feature may not be disabled.
Resetting Sleep Timer
The sleep timer is reset each time a shot is taken. It may also be reset manually by momentarily tapping the Link
Button. This also sends a test broadcast to all actively linked P1 Receiver units.
Auto Radio Wake
If the radio went to sleep as a result of the sleep timer running out, it will automatically wake up and resume normal
broadcasting if the Master flash is activated by taking a shot. The P1 Transmitter will not broadcast this first activation
so slave flashes will not activate. It will however resume an active state to broadcast any follow-up shots. You may
also awake the radio after entering the automatic sleep mode by tapping the Link Button one time to resume normal
broadcast operation.
Operating Instructions
Page 17