RadioMaster TX12, Инструкция по эксплуатации

Страница: 34 / 49

34
Weight:
Normal range is a value between ± 100% will be zoomed to the
gimbal operation. If you enter a negative value, for example -100% means reverse
the output. Note that channel inversion should not use negative values on the Inputs
page, and to reverse channels should be reversed on the Outputs page.
Offset : Midpoint offset setting
Curve : Curve settings
Diff Adjust the stroke amount on one side with the midpoint as the boundary
Expo
Expo curve setting. Increasing a positive value will make the gimbal smoother
and smoother when approaching the midpoint, while increasing a negative value
will make the gimbal more acute when approaching the midpoint.
Func
Preset
function
X>0
Func
Preset function
X<0
Positions above 0 (midpoint) follow the gimbal output, operations
below the midpoint are all fixed to the midpoint value of 0
|X| The opposite of the previous one
f>0
Absolute values, negative values less than the midpoint will always
become positive values, and the actual performance is a V-shaped
curve
f<0
Below the midpoint 0 is fixed at midpoint 0, above the midpoint is
fixed at 100, the actual performance is that the gimbal becomes 0
and 100 to switch, there is no intermediate process
|f| The opposite of the previous one
Cstm Call custom curve (CV1-CV32), custom curve is set in curve page CURVE
Modes : Select the corresponding flight mode, and the output trimming value
that affects this entry can be set by the flight mode entry
Switch : Select the switch to activate this item (Note: This setting is added to this
item to add multiple lines of different settings to switch, if there is only one line
setting, do not set the activation switch, otherwise the switch will cause this
item to be completely invalid)