RadioLink Electronic Ltd
3
and release, the led will flash quickly, meaning binding process is ongoing.
4. When the led stops flashing and is always on, binding is complete and there will be a signal tower shown
on top of the LCD screen of the transmitter. If not succeed, the led will keep flashing slowly to notify, repeat
the above steps.
Note
NO gyro by default as factory setting. Since integrated gyro in R7FG
will self-check, it is very important
to remain R7FG still when powering it on. GREEN LED (always on) indicates normal working mode while
GREEN+RED LEDs (always on) indicate gyro working mode. When RED is off means NO gyro. If binding is
not successful, the green led will keep flashing to notify.
Note of receiver usage
1. Keep the two antennas at a 90-degree angle (as shown on right):
2. Big models may contain metal parts that influence signal emission.
In this case, antennas should be positioned at both sides of the
model to ensure the best signal status in all circumstances.
3. Antennas should be kept away from metal conductor and carbon
fiber at least half inch away and no over bending.
4. Keep antennas away from motor, ESC or other possible
interference sources.
5. Sponge or foam material is advised to use to prevent vibration when installing receiver.
6. Receiver contains some electronic components of high-precision. Be careful to avoid strong vibration and
high temperature.
7. Special vibration-proof material for R/C like foam or rubber cloth is used to pack to protect receiver.
Keeping the receiver in a well sealed plastic bag can avoid humidity and dust, which would possibly make the
receiver out of control.
When all the above steps are complete, please turn off the transmitter and re-power on to test if the receiver is
correctly connected with it.
1.2.2 Working Mode
R7FG has four working modes:
Mode 1: PWM+PPM output ( factory setting by default)
When the green indicator is on, Ch1 to Ch6 output standard PWM while Ch7 outputs PPM. Short press ID
SET once to change Mode 1 to Mode 2 and three times within 1 second to Mode 4.
Mode 2: PWM+SBUS output
When the blue indicator is on, Ch1 to Ch6 output standard PWM while Ch7 outputs SBUS. Short press ID
SET once to change Mode 2 to Mode 1 and three times within 1 second to Mode 3.
Mode 3: PWM+SBUS Gyro
When both the red and the blue indicators are on (purple), Ch1 to Ch6 output standard PWM while Ch7
outputs SBUS. Meanwhile, gyro function is also on, stabilizing the direction, keeping car from slipping and
ensuring safer turning to preventing drifting from fast speed.
Short press ID SET once to change Mode 3 to Mode 4 and three times within 1 second to Mode 2.
Mode 4: PWM+PPM Gyro
When both the red and the green indicators are on (orange), Ch1 to Ch6 output standard PWM while Ch7
outputs PPM. Meanwhile, gyro function is also on, stabilizing the direction, keeping car from slipping and
ensuring safer turning to preventing drifting from fast speed.
Short press ID SET once to change Mode 4 to Mode 3 and three times within 1 second to Mode 1.