2. SBUS signal working mode:
SBUS signal output working mode: blue/purple LED indicates SBUS signal output, 10 channels
totally. SBUS and PWM signal possible working at the same time with SBUS signal output
working mode. CH9 output SBUS signal, the original CH1 output CH3 and original CH2 to
CH6 output CH6 to CH10 PWM signal at the same time.
SBUS and PWM signal change：
Short press the ID SET switch twice within 1 second, the signal is changed from normal
PWM to SBUS. The red LED indicates the normal PWM and blue/purple LED indicates SBUS
signal.
How to match code with transmitter:
1. Place the transmitter and the receiver close to each other within 1 meter.
2. Turn on the transmitter, then power on the R9DS.
3. Connect CH3 of R9DS to ESC.
4.
There is a black button on the R9DS, use a thin stick/pen press the binding button in one
second until the receiver light starts blinking and release, after about 8 times blinking, match
code success when receiver signal LED always on.
Installment of receiver antenna：
1. The antenna must be kept as straight as possible. Otherwise it will reduce the effective range.
2. Large model aircraft may of some metal part interfering signal, in this case the antenna should
be placed at side of the model. Then the best RF signal condition is obtained at any flying
attitude.
Содержание R9DS
Страница 2: ......
