RadioLink R8FG V2.1, Инструкция по эксплуатации

Страница: 9 / 12

RadioLink Electronic Ltd
www.radiolink.com
8
car to run to the bucket of the truck, and then switch the receiver ID on the truck to drag the car back to
the destination.
Subsidiary ID mode setting steps
:
1. Tap the button at the right of the "Subsidiary ID mode" to change it from "OFF" to "ON". Set the ID
number according to your cars or boats and then finish the bind and parameters set for each receiver.
2. Once finished the Subsidiary ID mode setting, the corresponding ID number will be displayed on the
main interface of RC8X. (For example: ID_1) Change the ID number by click "-" or "+", click Reset will
make the ID number back to ID_0.
7. Working Modes
R8FG has a built-in gyroscope, which can output not only PWM signals but also SBUS signals. There are
four working modes, including ordinary PWM mode, SBUS mode, Gyro mode, and Gyro + SBUS mode.
The channel signal corresponding to each mode is as follows:
R8FG Working Mode
Working Mode PWM Mode SBUS Mode Gyro mode
Gyro+SBUS
Mode
Note
Channel
Telemetry
Telemetry Port of Model Battery Voltage
（
+ -
）
TELEMETRY port is only for 2S-8S battery voltage telemetry. The port
cannot be used to power the receiver.
1 PWM PWM PWM PWM Steering
2 PWM PWM PWM PWM Throttle
3 PWM PWM PWM PWM Aux
4 PWM PWM PWM PWM Aux
5 PWM PWM PWM PWM Aux
6 PWM PWM PWM PWM Aux
7 PWM PWM PWM PWM Aux
8/SBUS PWM S.BUS PWM S.BUS Aux