Radioguide
®
VOX N40 Tourguide system
Stand-by 30 minutes: for saving energy, the transmitter will stand-by for 30 minutes then
turn OFF automatically if any audio signal input to this unit.
Recharging batteries:
Make sure NiMH rechargeable batteries are used.
Please switch OFF transmitter.
Put it onto charging stand.
For more details of charging stand, please refer to it's respective user manual.
When 2 or more transmitters will be used simultaneously make sure each transmitter is
separated at least 5 meters.
RECEIVER
Insert batteries:
Open battery door.
Insert 2x Alkaline batteries (AA 1.5V)
Close battery door.
To switch ON:
Press On/Off button for 0.5 second to switch ON.
Power indicator shows red light if no signal is received; it shows green light when
receiving signals.
LCD display shows selected channel and battery status as
.
Switched ON successfully.
To switch OFF:
Press On/Off button for 2 seconds then LCD will show OF (OFF), like
After “OF” disappears from LCD, the device is OFF.
Channel set up:
By pressing “+” button to move channel forward; pressing “-” button to move channel
backward.
Press “+” and keep it still will speed up channel moving forward, and vice versa.
Audio output:
Stereo earphone jack available for individual preference.
Use volume control to adjust volume level.
LCD display:
When LCD shows
, it stands for channel 1 is used and the battery is full.
When the sign of battery energy is “flashing” as
shows, it means the
batteries are out of power. Please replace with new batteries or recharge.
The sign of battery energy will keep flashing and LCD window will show “OF” (OFF)
then it turns off automatically if not replaced with new batteries, like
.
Stand-by 30 minutes:for saving energy, the receiver will stand-by for 30 minutes then turn off
automatically if any signal is received.
TROUBLE SHOOTING
1) Can not switch on:
1.
Check if batteries were inserted.
2.
Check the polarity of the batteries.
3.
Make sure batteries are in good condition.
4.
Check if batteries were out of energy.
5.
Return units to the place of purchase when above methods could not sort out problems
2) Receiver does not output any voice:
1.
Check if both transmitter and receiver are on same channel.
2.
Check if volume control on receiver is on a proper level.
3.
Check if microphone on transmitter or earphone on receiver were in good condition.
4.
Check if both transmitter and receiver were out of transmission and reception range.
w w w . v o x n e t w o r k . n e t
5
/
8
