Step I — Insert Batteries
Receiver for the PDLDT-305 Little Dog Trainer
• Use a small Philips screwdriver to remove the two screws on the receiver.
• Press the battery door up in the direction of the arrows on the door. It will move up
slightly and the door will release.
• Insert two, 3-volt lithium CR2032 batteries per the diagram on the receiver.
• Check to ensure the gasket is in place and clean.
• Replace the battery door.
• Tighten the screws. Do not over tighten.
Receiver for the PDBDT-305 Big Dog Trainer
• Use a small Philips screwdriver to remove the two
screws on the receiver.
• Remove the battery door.
• Insert two, 3-volt lithium CR2032 batteries per the
diagram on the battery door.
• Check to ensure o-ring is in place and clean.
• Replace the battery door. Press and snap door into
the receiver.
• Tighten the screws. Do not over tighten.
Hand Held Transmitter for Both Remote Trainers.
• Pull the battery door open at the top.
• Insert the 9V battery according to the diagram in the
transmitter. It will only fit one way.
• Replace the battery door by positioning the bottom
edge and snapping door into place.
• Ensure the receiver collar is not on the dog. Activate the
transmitter by pressing either the
or
button.
The transmitter LED will light.
3
Positive “+” polarity of battery
O-Ring for the PDBDT
Gasket for the PDLDT
Press Door Up Pull Door Out
400-594-1.id
4/3/03, 3:21 PM
3
