4
Charge the Drone Battery
Make sure you use the supplied battery and battery charging cable,
or one
of the same type: 3.7 V, 530mAH lithium polymer.
1
. Use the USB charging cable to connect the battery to a USB power
source. The LED on the USB connector lights red during charging, and
turns off when charging is complete.
A full charge takes about 100 minutes. A fully charged battery provides up
to 7 minutes of flight and camera time.
2.
After charging, unplug the USB charging cable. Do not attempt to
overcharge the battery.
3.
To install the battery, use a
screwdriver to open the drone
battery compartment door.
4.
Match and plug the two ends of the
white battery connectors. They
only fit one way, so do not use force.
Neatly slot the battery and cables into
the compartment.
5.
Screw the compartment door close.
Note:
To recharge the battery, you can
leave the battery inside the drone. Simply unplug the battery connectors, then
follow steps 1-2 to charge using the supplied USB cable.
Lithium Battery Notes
•
Do not charge longer than recommended. Unplug the charging cable when
the battery is charged.
• Do not attempt to charge or operate damaged toys.
• Do not puncture or crush. Do not disassemble.
• Do not dispose of lithium batteries in the trash.
• If the electrolyte in the cells should get on your skin, thoroughly wash with soap
and water. If in the eyes, rinse thoroughly with cool water. Immediately seek
medical attention.
2
1
Screw
LeD
