Figure 4. Inserting Cards into the Card Hopper
2/ Setting up the CR-510
Connect the Card Reader to a 110 Volt AC outlet or an approved power strip. Always use a 3-prong
grounded outlet.
Connecting the Card Reader to Your Computer
Model II Users
1. Be sure the Card Reader's and Computer's power are Off.
2. Connect one of the DB-25 ends of the Model II RS-232C Cable (26-4408) to the RS-232C
Connector on the CR-510.
3. Connect the other DB-25 end of the cable to either SERIAL CHANNEL A or B on the
Computer. Insert a Terminal Plug into the other SERIAL Connector.
Model III Users
1. Be sure the Card Reader's and Computer's power are Off.
2. Connect one end of the Model III RS-232C Cable (26-1408) to the RS-232C Connector on the
Computer.
3. Connect the other end of the cable to the RS-232C Connector on the CR-510.
Loading Cards
Be sure that the stack of cards to be read is packed so that all sides of the stack are even. No cards
should have edges protruding from the stack.
1. Insert the stack of cards (not over 250 regular size cards or 100 long cards at one time) face down
into the Card Hopper. The row of timing marks (black marks along the side of the card) should
be to the left as you face the front panel of the CR-510.
Содержание TRS-80 CR-510
