32103
Qty 9
32100
Qty 2
36300
Qty 6
12152
Qty 2
12148
Qty 2
33109
Qty 1
36214
Qty 4
33108
Qty 1
36210
Qty 2
31100
Qty 4
31106
Qty 2
31120
Qty 5
1.
Remove and identify all loose parts from carton
.
44249
13
16
17
31
24
28
23
25
26
9
11
12
40
29
(Qty 4 #36214)
1/4-20 X 1½”
Phillips Panhead
(Qty 4 #36300)
1/4-20 SS Locknut
2.
Position hopper on side. Install frame using (4) 1/4-20 x 1-1/2”
Pan Head Phillips bolts and (4) 1/4-20 nylon insert locknuts. First put
bolts through holes in frame then through holes in bottom of hopper.
Secure with locknuts.
TIGHTEN THESE LOCKNUTS NOW - DO NOT
TIGHTEN WITH POWER TOOLS. TIP: coat stainless steel bolts
with wax or grease before tightening to prevent them from seizing.
PAGE 1
90399 STAINLESS
HELPFUL HINTS:
READ THE DIRECTIONS BEFORE ASSEMBLY
If your spreader does not spread evenly, be sure the FRONT on the gear box points to the front of the spreader.
The impeller must turn clockwise. Reversing the gearbox will cause the impeller to turn counter clockwise.
Clean the impeller plate after each use. Ice melt stuck on the impeller blades will cause uneven spreading.
Your spreader is designed to be pushed at three miles per hour, which is a brisk walking speed. Slower or
Clean and dry your spreader thoroughly after each use. Coat all metal surfaces (
pay special attention to the
inside & outside of tubing - it’s easiest to do while assembling
) with light oil, Fluid Film
®
or silicon spray
Do not use powdered
materials.
Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.
PLEASE CONTACT US
IF YOU ARE MISSING ANY PARTS OR HAVE QUESTIONS REGARDING THE OPERATION OF
THIS SPREADER, VISIT THE EARTHWAY WEBSITE OR CONTACT SUPPORT AT:
.
PHONE: 574-848-7491 EMAIL: [email protected]
IF YOUR SPREADER COMES SEMI ASSEMBLED, SKIP TO STEP #7
ICE MELT SPREADER
ASSEMBLY & OPERATION
OCT 2019 REV
