10
OPERATION
SETTING THE TAD TO
ANSWER CALLS
After you have recorded an outgoing
message, you can set the TAD to an-
swer calls.
To set the TAD-779 to answer calls,
press
ANSWER
. The TAD announces,
“Answer on,” and the ANSWER indica-
tor lights.
To set the TAD to not answer calls,
press
ANSWER
again. The TAD an-
nounces, “Answer off,” and the AN-
SWER indicator turns off.
INCOMING MESSAGE
RECORDING
When the TAD is set to answer calls, it
plays the outgoing message, then
beeps. The caller can then record a
message up to 60 seconds long.
The TAD hangs up and resets to answer
the next call when:
• the caller hangs up
• the maximum message length is
reached
• there are more than 8 seconds of
silence
• you pick up any phone on the same
phone line as the TAD
If the TAD’s memory becomes full, it an-
swers a call after two rings and an-
nounces, “Memory is full.” Delete some
of the old messages to make room in
memory (see “Deleting Messages” on
Page 11).
Note: The maximum recording capacity
is 16 minutes.
SCREENING CALLS
To screen calls, let the TAD answer
them, then listen to the caller’s message
through the TAD’s speaker.
To adjust the volume, slide
VOLUME
on
the right side of the TAD.
If you decide to answer the call, pick up
any phone on the same phone line as
the TAD. The TAD stops recording and
resets to answer the next call.
If you do not want to take the call, simply
let the TAD finish recording the caller’s
message.
Illus. flash
on Answer
light.
43-779.fm Page 10 Monday, August 16, 1999 7:34 AM
