10
Replace Damaged Propellers
The left and right propellers of the drone
are different, and marked
A
/
B
on the
propeller and axles). You must use the
correct propeller in the correct location,
otherwise the drone will fail to take off.
To replace a damaged propeller, remove
the old one and press the new one onto
the propeller axle. If you cannot remove
the old propeller by hand, carefully use
pliers.
WArninG:
• To avoid injury and damage, check the propellers for nicks and breaks and make
sure they are securely attached before and after each flight. Replace any damaged
propellers.
• Use only the supplied propellers. Do not alter, modify, or customize the propellers.
Troubleshooting
Drone does not respond
•
Make sure the drone and remote control are switched on and paired.
•
Drone battery maybe low. Fully charge the battery. See
“Charge the Drone
Battery.“
•
Remote control batteries maybe low. Replace the batteries.
• Make sure the drone is within the control range (120 ft./36.5 m) and in line of
sight.
Drone difficult to control
• The throttle control is very sensitive. Use small, fine movements to control.
•
Practice in
ez
(Easy) mode.
•
Propellers maybe deformed or damaged. Adjust propellers by hand. If you
cannot adjust them, replace with the spare propellers.
Drone swerves or moves erratically before taking off
•
The gyroscope inside your drone needs calibrating: Do the following:
1.
With your drone and remote control switched on and paired (
ex
or
ez
),
place the drone on level ground.
2.
Move the throttle all the way down and the steering
forward at the same time. Hold this position for
a few seconds until the drone LEDs start to blink.
When the drone LEDs light steadily, release the
B
A
A
B
Back Blades (black)
front Blades (red)
6001438_PM_En_for inspection printing.indd 10
7/5/2016 4:33:51 PM
