8
4. Insert the supplied AC adapter’s
barrel plug into the
DC 12V
jack on
the back of the base.
5. Route the adapter’s cord through
the strain relief slot on the back of
the base.
6. Insert the tabs on the narrow end of
the bracket into the inner pair of
slots near the bottom of the base as
shown and snap the tabs at the wide
end of the bracket into place.
7. Plug the adapter into a standard AC
outlet. The message counter counts
down from
18
to
00
and the TAD-
1029 beeps.
8. Fully extend the base’s antenna and
place it in a vertical position.
Mounting the Base on a Wall
Plate
1. Remove the mounting bracket by
holding in both tabs and gently pull-
ing out the wide end of the bracket.
Strain
Relief
Slot
43-789.fm Page 8 Monday, August 16, 1999 8:32 AM
