connect both components with the supplied 16-foot (5 meter) CD
changer cable.
Do not mount the CD changer anywhere in your vehicle that is
exposed to direct sunlight (such as the front or rear deck) or
extreme heat (such as the engine compartment). Direct sunlight
or extreme heat can damage CDs and the CD changer.
Mount the CD changer as level as possible. If you cannot mount
the CD changer exactly level, make sure it will not tilt more than
15 degrees from the horizontal or vertical mounting position.
Make sure there is enough room for you to insert and remove the
supplied CD magazine from the CD changer.
For the Audio Adapter
You can mount the supplied Audio Adapter (ground isolator and FM
modulator) under your vehicle's dashboard.
Notes: The Audio Adapter's mounting area must be at least 5 inches (127
mm) wide and 1-1/16 inches (26.3 mm) high by 3-3/5 inches (91 mm)
deep.
When you choose a mounting area for the Audio Adapter, make sure
it is close enough to your vehicle's ground, power, and sound
system so you can connect them with the FM modulator and Ground
Isolator's wires and plugs (see "Connecting the Audio Adapter" in
Faxback Doc. # 57810).
For the CD Changer Controller
For ease of use, you can mount the supplied CD changer controller on the
dashboard using the supplied hook-and-loop fastening tape.
Note: When you choose a mounting area for the controller, make sure it is
close enough to the Audio Adapter's mounting area so the
controller's cord will reach the Audio adapter. The controller's
cord is about 5 feet (152 cm) long.
Removing The Transport Screws
The transport screws help protect the CD changer from damage during
shipment.
Before you mount the CD changer, use a small screwdriver to remove the
