36
37
INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTY OF MERCHANTABILITY OR OF
FITNESS FOR A PARTICULAR PURPOSE.
IN NO EVENT SHALL RADIO FLYER INC. OR ITS SUPPLIERS BE LIABLE TO YOU OR ANY THIRD
PARTY FOR ANY INDIRECT, INCIDENTAL, CONSEQUENTIAL, SPECIAL OR EXEMPLARY DAMAGES
ARISING OUT OF THE USE OF THE PRODUCT, INCLUDING, WITHOUT LIMITATION, PROPERTY
DAMAGE, LOSS OF VALUE OF THE PRODUCT OR LOSS OF USE OF THE PRODUCT, EVEN IF
RADIO FLYER INC. HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
Some states do not allow the limitation of implied warranties or the exclusion of consequential
or incidental damages, therefore the above limitation of implied warranties or the exclusion of
consequential or incidental damages may not apply to you. This warranty gives you specific legal
rights and you may also have other rights which may vary from state to state.
Federal Communications Commission (FCC)
Compliance Statement for USA
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy; if not installed and used in accordance with the instructions,
it may cause harmful interference to radio communications. There is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by powering the equipment off and on, the user is
encouraged to try to correct the interference by using any of the following measures:
• Reorienting or relocating the receiving antenna.
• Increasing the separation between the equipment and receiver.
• Connecting the equipment into an outlet on a circuit different from that to which the receiver is
connected. Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment.
Caution: Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
F L I G H T S P E E D ™ B AT T E R Y
Battery and Charger Safety Warnings
WARNING! TO PREVENT FIRE, EXPLOSIONS, OR ELECTRIC SHOCK:
• Before using the battery read all instructions and cautionary markings on the charger
and battery pack.
• Only use the specified Flyer™ charger (Model SPBC4802A, made by MDA Power
Technology Co limited) to charge this battery. Do not attempt to charge with any other
chargers. Replacement chargers are available to purchase exclusively at flyer.radioflyer.
com or by calling Radio Flyer Customer Service at 1-800-621-7613.
• Do not store the battery in locations where the temperature is below 14°F (-10°C) or
above 104°F (40°C)
• Do not charge the battery in temperatures below 32°F (0°C) or above 104°F (40°C). The
battery will not charge outside of these temperate limits.
• Do not operate the charger or battery if it has been impacted, dropped, or damaged in
any way.
• Do not use if the power cord is frayed, has broken insulation, or any other signs
of damage.
• If the plastic on the battery breaks or cracks, stop use and call Radio Flyer Customer
Service.
• Examine the charger and battery before each use and replace if wear or damage
is found.
• Do not incinerate the battery pack. The battery can explode in a fire.
• Never attempt to open or disassemble the battery pack or charger for any reason. Do
not puncture the battery.
• To prevent electric shock, do not immerse the charger or battery in water.
Do not attempt to charge if the cord or power adapter is wet.
• To clean, remove the charger/battery plug from the outlet and wipe with a dry cloth.
• During charging, the battery must be placed on a flat surface in a dry ventilated area.
• Do not place any object on top of the charger or place the charger on a soft surface that
may result in excessive heat. Place the charger away from any heat sources.
• The charger is designed to operate on a standard household electrical power (110/120
VDC). Do not attempt to use the charger on any other voltage level.
