Digital BUS-WATCH
®
SD40
Page 18 of 72
Radio Engineering Industries, Inc.
640434 -- Rev 0 -- 9/30/2011
Installation
System Wiring – Power and Camera Cables
Note:
All cables should be hidden from view.
For the basic system (shown in Figure 9 on Page 19), there are five cables,
one power (P/N 512002 – 16 Feet, or 512001 – 35 Feet) and 4 camera (P/N 510993
or any different length cable). For external record indication and alarm/event
marking, the record indicator / event mark button harness (P/N 511986) is available
(shown in Figure 10 on Page 20). The GPS harness (P/N 710144) is used for
satellite location and movement information (shown in Figure 11 on Page 21). For
additional vehicle monitoring, the BUS-WATCH® vehicle sensor options harness
(P/N 512008) is available.
Connect the camera(s) using cable P/N 510781, or equivalent. There is no specific
orientation for camera cables to be installed. If multiple types of cameras are installed in
a single system, be careful to note which cameras are located where. Use lenses with
more magnification (8mm) to bring objects closer. Use lenses with less magnification
(4mm) for wide angle viewing.
Connect power using cable P/N 512002, or equivalent. The black wire connects to
the negative terminal of the battery. The white wire (labeled 12V Battery) connects
directly to the positive terminal of the battery.
The white wire should be fused at 10
Amps
see Figure 9.
WARNING
DISCONNECT VEHICLE BATTERY VOLTAGE BEFORE INSTALLING
System WIRING
WARNING
DISCONNECT POWER TO THE DIGITAL BUS-WATCH® BEFORE
JUMP STARTING VEHICLE
WARNING
INSTALL DVR HORIZONTALLY. USE EXTERNAL SHOCK AND
VIBRATION DAMPENING IF NEEDED.
