AC Input
DC Input
Cooling
Fan
Balance Ports
Output 1
Output 2
BUTTONS
CONNECTION DIAGRAM
STOP
ENTER
STATUS
Battery
Type
Decrease
Increase
Start
Press this button to make selections in the main menu, to return to
the main menu and to stop the current process.
The Reduce and Increase buttons are used to browse through
status menus during the charge or discharge process. When
adjusting parameters, press the Increase and Decrease buttons to
alter the values.
Use this button to confirm the value you have entered and move to
the next menu. To begin the selected process, press and hold the
button for a minimum of 2 seconds.
STOP
Battery Type
STATUS
Decrease Increase
ENTER
Start
WARNING
:
This diagram shows the correct way to connect your battery to the Duplex charger when
carrying out a balance charge.
Failure to connect as shown in the
diagram below may damage this
charger.
If using alligator clips or a charging
squid, ensure that none of the connector
contacts can touch (together or a
conductive surface) and short out which
could cause damage to the charger
and/or battery.
1>Measure Internal Resistance Program
2>Check a battery’s capacity
3>Balancing a LiXx battery
balanced.
In this program, the charger can measure the internal resistance of each individual
cell. This feature is only available for lithium batteries.
Use this program to measure the internal resistance of a
lithium battery pack.
The two lines show the first to the sixth cell’s internal
resistance. This information is only available for lithium
batteries. Press the ‘Decrease’ or ‘Increase’ button to
display more information.
Use this program to check the capacity of a lithium battery.
Press the ‘Start/Enter’ button to select the battery type then
‘Decrease’ or ‘Increase’ to choose LiPo/LiHV/LiFe/Lilo.
Press the ‘Start/Enter’ button for longer than 3 seconds.
The display will show the lithium battery’s status during the
balancing of the pack.
Press the ‘Decrease’ or ‘Increase’ button to display the
capacity of your battery pack while it is being balanced.
In this program,you can simply balance your 2-6S LiXX
batteries using the integral balancer. The program displays
the voltage for each cell in your battery pack.
Press the ‘Start/Enter’ button twice, then press the
‘Decrease’ or ‘Increase’ button to select the battery type
(LiPo/LiHV/LiFe/LiIo).
Press the ‘Start/Enter’ button for more than 3 second to
begin the balancing process. The total voltage of the battery
is displayed.
Temperature Probe Ports
7
22
