Owner’s Manual – Gas Storage
2
H3958 026271 Rev. A
Pool Heating
This water heater must
not
be used for
pool heating.
Installation Requirements
This water heater must be installed
by a licensed tradesperson, and in
accordance with:
• AS/NZS3500.4 “National Plumbing
and Drainage Code Hot Water
Supply Systems – Acceptable
Solutions”.
• AS5601/AG601 “Gas Installations”.
• Local authority regulations.
• Outside Australia and New Zealand,
please refer to local plumbing and
building codes and regulations.
• Notice to Victorian customers
from the Victorian Plumbing
Industry Commission – this water
heater must be installed by a
licensed person as required by the
Victorian Building Act
(1993). Only
a licensed person will give you a
compliance certificate, showing
that the work complies with all
the relevant Standards and only a
licensed person will have insurance
protecting their workmanship for 6
years.
Outdoor Tank Installation
The water heater must be installed
outdoors, with the minimum clearances
as shown in the figure below.
A = 500mm B=300mm min
For further details, refer to
AS 5601 – Gas Installation Code
We recommend a fire-proof plinth
be installed under the water heater.
Minimum clearance around the windows
and doors must be maintained – refer to
AS 5601.
Location
The water heater should be located as
close as possible to the most frequently
used hot water outlet. Ensure that the
data label is clearly visible and that there
is adequate access for servicing the unit.
Note
: All models are equipped with a
sacrificial anode, accessible through the
top cover. Allow 50% of the height of
Installation Details
