RADIAND CT-180- s120, Руководство пользователя

Страница: 16 / 24

Trouble Shooting
If the above method cannot solve your problem, please contact manufacturer’s tech-
nician without delay.
No. Failure
performance
Cause analysis Trouble shooting
1 Not heating up 1. Power supply problem Check the line and power supply
by qualified electrician and check if
it meets requirement
2. Water shortage Fill water to the level of down float
operation position
3. Down float switch
malfunction
Clean down float switch, and/or
replace new switch.
2 Low water
temperature while
cooking
1. Power supply problem Check voltage. If it is 210~240V
2. Fill in too much water Check if upper float switch is
flexible. If overflow pipe insert well.
If water sink leakage.
3. Too much scale on
thermal sensor.
Remove scale
3 Big difference
between actual
temp. and display
temp.
1. Too much scale on
thermal sensor.
Clean thermal sensor
2. Thermal controller
malfunction
Contact factory technician
4 Do not blend 1. Water shortage Fill water to the level of down float
operation position
2. Down float switch
malfunction
Trouble shooting
3. Blend motor damaged Replace new motor
4. Impeller damaged Replace new impeller
5 Weak blend 1. Less than four impellers Replace new impeller
2. Spout case installed
incorrect
Re-install spout case as required
3. Temp. setting too high Re-setting temperature
6 No display on
control panel
1. Steam get into control
system
To avoid steam into, replace
control panel
2. Line defective on control
panel
Contact factory technician
7 Lifters do not up
and down (or fuse
failure)
1. Steam get into and
cause control panel failure.
To avoid steam into, replace
control panel
2. Lift system malfunction Check lift system
8 Can not fill water
automatically
1. Up float switch
malfunction
Check float if flexible or damaged
2. Inlet valve damaged Replace the valve
9 Can not fill water
manually
1. No water in inlet hose Check inlet hose if there is water
in it.
15