![background image](http://html1.mh-extra.com/html/radialight/calypso-digital/calypso-digital_installation-and-operating-manual_3221537019.webp)
19
After displaying and editing all the
hours of the day, at 23 o'clock (from
23:00 to 23:59), a further pression of
the "+" key stores the program.
Display shows "donE" for 5 " to con
-
firm the storage
Note:
You can store the settings and exit
programming mode, at any time, wi-
thout having to display all the hours
of the day by pressing the "PROG"
key
•
Display/Change the comfort temperature
You can view and / or modify the comfort temperature set at any time, by pressing the "+" and "-" keys. Every time
you hit the button will correspond a 0.5 ° C variation.
In a room with a temperature exceeding 30°C, it could happen that the thermostat does not turn on the fan heater even
if it is at maximum. Vice-versa, in a room with a very low temperature (below 5°C), it is normal that the thermostat keeps
the heater constantly on, even if it is at minimum.
NOTE
: The temperature measured by the inner sensor of the product is representative of the ambient temperature
nearby it and it may differ from the temperature measured using other instruments in other areas of the room. That
difference may depend on many factors including, for example:
- the installation position: some areas of the room may be affected by drafts or hot air sacs that modify the sensor
measurement;
- unstable conditions: any evaluation must be done in stable working conditions. For this purpose comfort temperature
should be changed only 60min after a previous change . It is not possible, indeed, to evaluate the room temperature
maintained by the product correctly if the comfort level temperature is continually changed in a short time.
If a difference between set temperature and room temperature is detected in stable working conditions, measure the
difference and then increase or decrease the comfort temperature on the product of the exact value of measured
difference.
4. s
uPPly
corD
•
When using the heater the supply cord mus always be completely unwrapped and never in touch with any part
of the heater (see picture 6).
•
When the heater is not in use and disconnected from the net, the supply cord can be rolled up around the pede-
stal and the plug may be locked to the cord to facilitate the storage (see picture 7).
5. t
roubleshooting
•
In the event of overheating, the safety device on the appliance automatically disabled the heating elements and
motor. As a result, the heater stops working and the pilot light will remain switched on . In this case:
-
Turn off the fan heater putting the switch lever in 0 position and allow it to cool down for about 15/20
minutes.
-
Eliminate any other possible reasons for overheating (e.g.: obstructions in front of the air inlet/outlet grilles,
build-ups of dirt).
-
Turn on the fan heater again and check it works correctly.
6. m
aintenance
•
This product does not require any special maintenance.
•
Clean the product with a dry cloth once every 6 months and use a vacum cleaner to suck up any dirt should be
Содержание CALYPSO DIGITAL
Страница 2: ...2 Volume 3 Volume 1 Volume 2 60cm 60cm 2 25m 60cm 1 4 B A 3 1m 1m 2 D C...
Страница 3: ...3 5 7 6...
Страница 32: ...32 CALYPSO DIGITAL_R4_20180627...