25
i
EN
i
12. Purging
If an actuator is unavailable, you can use this function to permanently log the actuator off of
the DuoFern sun sensor. An unavailable actuator increases the energy consumption of the
DuoFern sun sensor unnecessarily and should be avoided.
1.
Press the
Connect button (2) for 5 seconds
.
2.
Note the status LED
(1)
, which:
◆
flashes red, while Purging“ is active
◆
lights up green for one second, once „Purging“ is complete.
13. Apply the current sunshine position
This function can be used to force the actuators to apply the current position of the blinds as
the sunshine position.
1.
Move the blinds manually from top ( 0%) to the desired sunshine position.
2.
Press the
Disconnect button (3) quickly twice
.
3.
The DuoFern sun sensor then transmits a signal to every actuator registered.
4.
Every actuator registered applies the current position of the blinds as the new
sunshine position.
NOTE
Read the operating instructions for the relevant actuators and check the actuator settings
for the „Runtime“
