rada Autotherm-3 EV, Руководство по эксплуатации продукта

Страница: 13 / 24

13
3. Drill two 7.0 mm holes at 607 mm centres, avoiding any buried cables or pipes,
and fit the wall plugs supplied.
Note!
Installers may wish to obtain alternative proprietary cavity fixings, when
installing on to a dry lined, stud partition, shower cubicle or laminated panel
wall structures. However, these methods of fixing are beyond the scope of
this guide.
4. Assemble the clamp bracket components.
5.
Push the slide bar through the clamp bracket assembly. Push the soap dish
and the hose retaining ring onto the bottom of the slide bar. For category 5
installations the security hose retaining ring is already attached to the hose.
6. Insert the fixing screw into the hole of the slide bar support. Fit the bottom slide
bar support loosely to the wall to make aligning the top support easier. Push
the slide bar into the support.
7.
Push the slide bar into the support. Place the screw through the top support
and fully tighten.
8. Fully tighten the bottom support.
9. Fit the end caps over the ends of the slide bar supports.
10.
Screw the hose onto the outlet of the shower control, or the right angled connector
(Make sure that the hose seal is fitted).
Do not overtighten
(hand tight should
be sufficient).
11. Pass the flexible hose through the hose retaining ring (category 3 only) and
screw the remaining end of the hose onto the handset (Make sure that the hose
seal is fitted).
12. Place the handset into the slide bar clamp bracket.
Note!
The clamp bracket is tapered. The handset will only fit properly from one
direction. If necessary turn the end of the clamp bracket until the handset will
fit.
The clamp bracket has a central securing screw which can be tightened to
increase the friction lock and prevent the handset from pivoting downwards.