35
f)
DO NOT squeeze the throttle control. Crouch in the starting position (Fig. 7).
g) DO NOT squeeze the throttle control. Pull the starter rope with a controlled and steady motion 3 to 5
times to start the engine (Fig. 7).
h) Allow the engine to warm up less than 10 seconds, then squeeze the throttle control to return the choke to
the Choke OFF position and operate the blower.
If the engine does not start, begin the starting procedure with step 3.
If the engine fails to start after a few attempts, squeeze the throttle control to return move the choke to the
Choke Off position. Pull the starter rope with a controlled and steady motion 3 to 8 times. The engine should
start. If it does not, repeat this instruction.
IF THE UNIT WAS RUN FOR 10-15 MINUTES AND THE ENGINE IS HOT... perform steps 3, 5, 6, 7 to
restart the engine. Squeeze and hold the throttle control. Run the unit for 2-5 minutes, or as needed. The unit
may be used during this time.
If the engine speed fluctuates, move the choke lever to the Full Choke position and run the unit for 2-5
minutes, or as needed. The unit may be used during this time. Then squeeze and hold the throttle control to
operate the blower.
2) STOPPING INSTRUCTIONS
a)
Release the throttle control and allow the engine to idle.
b)
Press and hold the ON/OFF switch in the OFF (STOP) position until the engine comes to a complete stop
(Fig. 5).