Racing RACFBE65T, Руководство пользователя

Страница: 13 / 19

6. CLEANING, MAINTENANCE AND STORAGE
6.1 CLEANING
Attention!
Pull out the power plug before carrying out any cleaning work on the equipment.
We recommend that you clean the equipment immediately after you use it.
Clean the equipment regularly with a damp cloth and some soft soap. Do not use cleaning agents
or solvents; these may be aggressive to the plastic parts in the equipment. Ensure that no water
can get into the interior of the equipment
6.2 Maintenance
Attention!
Pull out the power plug before carrying out any maintenance work on the equipment.
We recommend:
The splitting wedge is a wearing part that needs to be sharpened or replaced after wear.
The combined gripping and controlling device must remain smooth running. Lubricate with
a few drops of oil when necessary.
Keep splitting wedge drive clean of dirt, wood shavings, bark, etc.
Lubricate slide rails with grease.
When must the oil be changed?
Change the oil after 150 working hours.
Oil change (fig. 11)
1) Move the log splitter into the start position and pull out the mains plug.
2) Remove the tray table beforehand.
3) Undo the oil drain screw with dipstick (K) and put it to one side.
4) Turn the log splitter on the support leg side as shown in fig. 11 over a 4,5 liter capacity
container to drain the hydraulic oil off. Recycle carefully! Dispose of the waste oil in an
environmentally friendly manner!
5)
Turn your machine on the motor side as shown in Fig. 10 to refill about 4,2 l fresh oil.
6) Clean the oil drain screw with dipstick (K) and screw it back in to the machine that is still in
a vertical position. Unscrew it again; there should be an oil film between the notch.
7)
Now screw the oil drain screw with dipstick back in tightly. Afterwards start splitting without
actually splitting log several times.
8)
Check the oil level one last time and top up with a little oil if required.
Dispose of the used oil in a correct manner at a public collection facility. It is prohibited to
drop old oil on the ground or to mix it with waste.
We recommend oil from the HLP 32 range.
Connections and repairs
Connections and repairs of electrical equipment may only be carried out by an electrician.
Please provide the following information in the event of any enquiries:
Type of current for the motor
Machine data - type plate
Machine data - type plate
Service information
Please note that the following parts of this product are subject to normal or natural wear and that
the following parts are therefore also required for use as consumables.
Wear parts*: splitting wedge guides, hydraulic oil, splitting wedge
* Not necessarily included in the scope of delivery!
6.3 Storage
Store the device and its accessories in a dark, dry and frost-proof place that is inaccessible to
children. The optimum storage temperature is between 5 and 30˚C. Cover the electrical tool in
order to protect it from dust and moisture.Store the operating manual with the electrical tool.
13