Racing RACFBE65T, Руководство пользователя

Страница: 12 / 19

must be immediately added. The upper notch indicates the maximum oil level. The machine must
be on level ground. Screw in the oil dipstick fully, to measure the oil level.
5.2 Ventilation screw
Before operating your machine, the bleed screw should be loosened by some rotations until air
can go in and out of the oil tank smoothly. Failed to loosen the bleed screw will keep the sealed air
in hydraulic system being compressed after being decompressed. Such continuous
compression/decompression will blow out the seals of the hydraulic system and cause permanent
damage to your machine.
Before moving your machine, make sure the bleed screw is tightened to avoid oil leaking from this
point.
5.3 Splitting logs
Only split logs that have been sawn off straight. To do this, proceed as follows:
1) Place the log plain onto the work table.
2) Your machine is equipped with Two-hands Control System that requires to be operated by both
hands of the user
– left hand controls the control lever (1) while right hand controls the push
button switch (6).
3) Simultaneously push button switch (6) to start the splitting action.
The log splitter will freeze upon absence of either hand.
Never force your machine for more than 5 seconds by keeping pressure on it to split excessively
hard wood.
After this time interval, the oil under pressure will be overheated and the machine could be
damaged. For such extremely hard log, rotate it by 90° to see whether it can be split in a different
direction. In any case, if you are not able to split the log, this means that its hardness exceeds the
capacity of the machine and thus should be discarded to protect the log splitter.
5.4 Wrongly placed log
Always set logs firmly on the log retaining plates and work table. Make sure logs will not twist, rock
or slip while being split. Do not force the blade by splitting logs on the upper part. This will break
the blade or damage the machine.
Do not attempt to split 2 pieces of logs at the same time. One of them may fly up and hit you.
5.5 Jammed log
Do not try to knock the jammed log off. Knocking about will damage the machine or may launch
the log and cause accident.
1.
Release both controls.
2. After the log pusher moves back and completely stops at its starting position, insert a
wedge wood under the jammed log.
3.
Start the log splitter to push the wedge wood under the jammed one.
4. Repeat above procedure with sharper slope wedge woods until the log is completely freed.
12