Racing RAC1036ET, Руководство пользователя, Страница: 15 / 24

6. MAINTENANCE AND STORAGE
Before carrying out maintenance operations, disconnect power supply.
CAUTION: Always clean the tiller after each use. Failure to carry out proper cleaning can result in
damage to the tiller or result in poor performance.
Clean the underside of the motor support plate and housing around the tines with a scrub brush,
and a soft cloth dampened with a mild soap and water mixture.
Never use a water hose to clean the tiller! To remove soil and debris from the transmission and
tines, use a stiff brush or a dampened cloth. Clean the vents on the motor housing and remove
any remaining grass or dirt. Once cleaned, wipe the tines and shaft dry and apply a light coat of oil
to prevent rust.
Tines Removal and installation (Fig. 6):
Worn tines invite poor performance and overload of the motor. Check tines before each use.
Sharpen or replace the tine assemblies with new ones when necessary. Call our customer service
help line.
WARNING: Injury can occur while working on the tines. Wear protective gloves.
To remove the complete tine assemblies from the shaft, remove the M8 X 40 hex head bolt from
the shaft. Remove the tine assembly from the shaft. Reverse above steps to install tines.
Adding Transmission Lubricant (Fig. 7):
Drain screw plug is located on the right side of transmission housing. Lay the tiller on its left side
and clean the transmission of dirt and debris prior to removing the drain screw plug. If necessary,
remove tine assemblies to have better access to the drain screw plug. Use a 5mm hex key to
unscrew the plug.
Empty the oil from the transmission. Fill with a high-quality SAE 30 weight oil, until it begins to
seep out around the hole. Reinstall the drain screw plug.
Replace worn or damaged parts with original replacement parts only. Parts from another tiller/
cultivator may not fit properly causing an unsafe situation.
Make sure all protective devices are secure and in good condition. Repair or replace if necessary.
STORAGE
Store the Tiller in a dry, clean area out of reach of children.
During extended periods of storage, ensure that the tiller/ cultivator is protected against corrosion
and frost.
M8 X 40
M8 X 40
M8
M8