910103
Hydraulic Rail Profile Grinder
Phone: (262) 637-9681
Email:
9.2023 Rev 2.4
Original Instructions
Page
12
of
21
Stone Height Adjustment
The stone can be adjusted to a desired height by turning the large hand wheel at the center of the Profile
Grinder.
Use the smaller knob located under the hand wheel as a brake to increase or decrease drag on the hand
wheel.
Frame Rotation
The Grinder’s frame can be set at any position within a 90° arc by loosening the locking lever and pulling
the frame towards the handle.
Always turn the locking lever into a locked position before grinding.
Grinder Operation
1. Place the Profile grinder on the rail with the two large diameter guide wheels on one side of the rail
and the two smaller diameter wheels on the opposite side.
The grinder should set on the rail at each roller and roll back and forth freely.
2. When grinding, position the weld between the left set of wheels and the stone housing (left and right
are determined from
the operator’s position at the handle).
3. Adjust the stone in installed, run the grinder at full speed for one minute before grinding.
4. Grip the handle firmly with both hands and draw the trigger to the handle to start the grinder. With the
grinder at full speed move it from the right to the left into the weld.
5. Adjust the stone height and rotate the frame as required for optimum results.
6. When finished release trigger and allow stone to stop before removing the grinder from the rail.
