Using the NTRIP Modem with VBOX 3i ADAS
Using SIM Card
Using Wi-Fi Connection
1. Attach the supplied antenna (ANTMSTUBSMAM)
to the SMA connector on the
top of the unit
.
2. Insert the SIM card into the slot at the top of the
unit.
The logo on the SIM card must face the front of the
modem and the chamfered edge must be inserted
first.
Notes
:
Make sure that the SIM card has been activated
before you insert it into the modem.
If the SIM card can be broken down into a Micro/
Nano SIM, make sure that it is stable when you
insert it into the modem as the Micro/Nano
SIM could become detached from the card inside
the modem.
3. Connect the Hirose end of the RLCAB170 to the
Hirose connector at the
bottom of the NTRIP
modem.
4. Connect the other end of the RLCAB170 cable to
the DGPS port on the VBOX 3i ADAS.
This cable provides power to the modem from the
VBOX unit.
Note: When you use the NTRIP Modem for the first
time, it becomes a Wi-Fi access point
5. Use a phone or computer to open an internet
browser and enter the IP address in the address
bar to log in to the modem’s access point.
6. Press the
Change settings
button next to the
Modem
heading.
7. Enter the APN, Username and Password
associated with your network provider.
1. Attach the supplied antenna (ANTMSTUBSMAM)
to the SMA connector on the
top of the unit
.
2. Connect the Hirose end of the RLCAB170 to the
Hirose connector at the
bottom of the NTRIP
modem.
3. Connect the other end of the RLCAB170 cable to
the DGPS port on the VBOX 3i ADAS.
This cable provides power to the modem from the
VBOX unit.
Note: When you use the NTRIP Modem for the first
time, it becomes a Wi-Fi access point
4. Use a mobile phone or a Wi-Fi-capable computer
to navigate to the Wi-Fi settings on the device and
connect to the modem’s hotspot.
5. Use a phone or computer to open an internet
browser and enter the IP address in the address
bar to log in to the modem’s access point.
The need to open a browser and enter an IP
address is the same between both SIM and WiFi.
6. Press the
Change settings
button next to the Wi-
Fi heading.
7. Enter the name and password of the hotspot you
want to use.
Note: The Hotspot must have a name consisting of
alphanumeric characters only.
8. Press the
Save and restart
button.
Note: The settings are retained after power cycles
and the modem will attempt to auto-connect to the
Wi-Fi hotspot when powered up.
https://en.racelogic.support//ADAS_Testing/ADAS_Hardware/Peripherals/Telemetry_Systems/NTRIP_Modem
2
