Racelogic LabSat 3, Руководство пользователя

Страница: 25 / 62

The Digital menu allows CH1 or CH2 (subject to LabSat variant) to be configured to record any of the following
parameters:-
Function Description Option or Standard
1PPS
This is the 1 Pulse Per Second
output from the internal GNSS
monitor and will become active once
the internal GNSS monitor has a
position fix. Note, that if using
battery power with the power save
option enabled, the GNSS monitor
will power-down after approx 30
seconds into the recording and
therefore not be present in the
recorded data. During replay, the
recorded 1PPS signal will be output
on pin 2 (DIGO) of the expansion
connector.
Standard
CAN
CAN 1 and CAN 2 on the expansion
connector (RLACS202) will be
recorded on channel 1 & 2 of the
LabSat 3. See section CAN BUS
for more details.
Option on Single constellation
variant*
RS232
This will record an RS232 level
signal input on pin 18 of the
expansion connector. During
replay, pin 17 of the expansion
connector will output the recorded
data at RS232 level. Because the
RS232 signal is digitized directly, it
is not necessary to configure baud
rate.
Option on Single constellation
variant*
DIGI
Will record the digital state of pin 3
of the expansion connector. During
replay, the signal will be re-created
on pin 2 (DIGO) of the expansion
connector. See section
EXPANSION CONNECTOR for
more details.
Option on Single constellation
variant*
*Contact Racelogic or your LabSat distributor to purchase upgrade options
https://racelogic.support/03LabSat_GPS_Simulators/LabSat_3/LabSat_3_User_Manual/
25