7
RN PRO Main Unit Installation
A.
Connect the RN Clamp to the RN PRO (page 14). Take the holder and screw it to
the device with the clamp. In the vehicle, put the sucker of the holder below the
rear-view mirror and fasten it tight to the windscreen with the clamping lever.
Make sure that the mounted RN PRO can record videos properly. In general, the
best position is about 5
10 cm above the dashboard.
Adjust the RN PRO so that the top is approximately in balance.
Check the
position by recording a test video.
NOTE: Before every ride, check the adherence of the holder. An incorrectly
installed device might get detached from the windscreen and get damaged,
causing damage to the car or serious injuries to the driver.
B.
RN PRO can be also installed using the car chassis mounting screws. You can
directly mount the main unit on the floor or to the roll cage in your racing car.
Turning on the RN PRO Main Unit
Turn the RN PRO on by pressing the Power button
for at least three seconds.
Turning off
Turn the RN PRO or RN PRO Wi-Fi Dashboard off
by pressing the Power button for a brief moment.
Wait for powering off the device.
Holes for car chassis mounting screws
Содержание RN PRO
