Rac RAC-HP009, Инструкция по эксплуатации

Страница: 6 / 13

OPERATING INSTRUCTIONS
Note:
Before connecting to the mains power supply
please ensure that the ON / OFF switch is in
the OFF position (Fig 5), the water supply is
connected and is turned on.
Running the pressure washer without any
water supply will damage the pump.
Instructions for use
a) With the unit fully assembled, ensure that
the unit is switched OFF and is connected to
the mains and the water supply. Pull
the trigger a few times to expel any air trapped
in the system.
b) Ensuring that the trigger is released, switch
ON the pressure washer. The unit is now ready
to operate by pulling the trigger.
Note:
The motor only runs when the trigger is
operated.
When the pressure washer is not in use,
lock off the gun trigger for safety reasons (Fig 6).
Switch the unit OFF when not in use for
extended periods of time.
Never operate the pressure washer without
the water supply connected and turned on.
Helpful Hints
Before using remove any objects
which could create a hazard.
Ensure that all doors and windows are closed
(where appropriate).
The adjustable lance allows you to use a
variety of spray patterns from a fan to a pencil
jet (fig 7). When using the pressure
washer to clean decking, patios, vehicles, etc.,
always start by using the fan spray and
begin spraying from a minimum 30cm away
to avoid damaging the surface of the
material to be cleaned.
WARNING: Do not adjust the nozzle while
the trigger is squeezed.
The pressure of the spray on the surface
you are cleaning increases as you move
the nozzle closer to the surface. We
recommend that for most cleaning
applications a 45° spray angle should be
used to avoid damaging the surface being
cleaned. Spraying directly head-on tends to
cause dirt particles to embed in the surface.
-5-
Fig 5
ON OFF
Fig 7
The spray can be adjusted from a pencil jet
to a fan by turning the nozzle (Fig 7).
Fig 6
LOCK OFF