![background image](http://html1.mh-extra.com/html/rabbit/rcm3365/rcm3365_user-manual_3124182040.webp)
34
RabbitCore RCM3365/RCM3375
4.2 Serial Communication
The RCM3365/RCM3375 does not have any serial transceivers directly on the board.
However, a serial interface may be incorporated into the board the RCM3365/RCM3375
is mounted on. For example, the Prototyping Board has RS-232 and RS-485 transceiver
chips.
4.2.1 Serial Ports
There are six serial ports designated as Serial Ports A, B, C, D, E, and F. All six serial
ports can operate in an asynchronous mode up to the baud rate of the system clock divided
by 8. An asynchronous port can handle 7 or 8 data bits. A 9th bit address scheme, where
an additional bit is sent to mark the first byte of a message, is also supported.
Serial Port A is normally used as a programming port, but may be used either as an asyn-
chronous or as a clocked serial port once the RCM3365/RCM3375 has been programmed
and is operating in the Run Mode.
Serial Port B is available on the RCM3365/RCM3375, and may be used as an
asynchronous port. PB0 is used to enable Dynamic C to detect whether the
xD-Picture
Card
is installed. If the card detect is not needed by your application program, you may
remove R96 (see Figure A-5) to disable the
xD-Picture Card
detect, and then use Serial
Port B as a clocked serial port.
Serial Ports C and D can also be operated in the clocked serial mode. In this mode, a clock
line synchronously clocks the data in or out. Either of the two communicating devices can
supply the clock.
Serial Ports E and F can also be configured as HDLC serial ports. The IrDA protocol is
also supported in SDLC format by these two ports.
4.2.2 Ethernet Port
Figure 8 shows the pinout for the RJ-45 Ethernet port (J2). Note that some Ethernet
connectors are numbered in reverse to the order used here.
Figure 8. RJ-45 Ethernet Port Pinout
Three LEDs are placed next to the RJ-45 Ethernet jack, one to indicate an Ethernet link
(
LINK
) one to indicate Ethernet activity (
ACT
), and one to indicate the 10/100Base-T speed.
The RJ-45 connector is shielded to minimize EMI effects to/from the Ethernet signals.
ETHERNET
RJ-45 Plug
1. E_Tx+
2. E_Tx
3. E_Rx+
6. E_Rx
1
8
RJ-45 Jack
Содержание RCM3365
