INSTRUCTIONS
GT500R/L INSTALLATION
RAB Lighting is committed to creating high-quality, affordable, well-designed and energy-efficient LED lighting and controls that make it easy for electricians to install
and end users to save energy. We’d love to hear your comments. Please call the Marketing Department at 888-RAB-1000 or email: [email protected]
Fig. 3
WIRING
PICKING A LOCATION
Fig. 4
Location Considerations:
• Choose a location from which the sensor can “see” all the paths of
movement that will be illuminated by its lights.
• If wall mounting, locate 8-10’ high for optimum range and
detection. Lower mounting height will reduce range. Sensor must
be below and as far as possible away from lights.
• Mount on stable surface that is protected from rain.
• Do not mount on a pole or tree that sways in the wind.
• Sensor functions best when the direction of expected movement
is across its detection pattern, not towards the sensor.
Easy Wiring Tip:
Use “S” shaped EZ Hang Hook to hold the cover
plate and sensor for hands free wiring.
•
Strip incoming supply wires 3/8” to 1/2”.
•
Make connections shown left of the dotted line.
•
The Red Pigtail is only used if you are remotely switching
additional fixtures.
Fig. 5
DETECTION PATTERN
Fig. 6
70FT
50 FT
8-10 FT
50 FT
Fig. 7
AIMING AND WALK TESTING
Test Period:
The sensor has a Test mode which allows it to be
aimed and walk tested day or night.
• Switch the sensor to Test mode by adjusting the time control to
test setting. Power on sensor.
• During the 60 second warm up period, the lights will be turned
on. During this time, test that all fixtures and lamps function
properly.
• After the warmup period, the sensor will keep lights on for 5
seconds each time it detects movement in its Detection Zone.
• Once the Detection Zone is tested, adjust the sensor Time control
to desired standby time.
