WP3LED INSTALLATION INSTRUCTIONS
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: [email protected]
TROUBLESHOOTING
1. Check that the line voltage at the fixture is correct. Refer
to wiring directions.
2. Is the fixture grounded properly?
3. Be sure the photocell, if used, is functioning properly.
CLEANING & MAINTENANCE
CAUTION: Be sure fixture temperature is cool enough
to touch. Do not clean or maintain while fixture is
energized.
1.
Clean glass lens with non-abrasive glass cleaning
solution.
2.
Do not open the fixture to clean the LED. Do not touch
the LED.
Easy Answers
rabweb.com
Visit our website for product info
Tech Help Line
Call our experts - 888 722-1000
Answered promptly - [email protected]
Free Lighting Layouts
Answered online or by request
© 2017 RAB LIGHTING Inc.
Northvale, New Jersey 07647 USA
WP3LED -IN-0917
Note: These instructions do not cover all details or variations in equipment nor do they provide for every possible situation during
installation, operation or maintenance.
PHOTOCELL INSTALLATION
Photocell may be installed in the field. Apply weatherproof
silicone sealant to all plugs,, around photocell and unused
conduit entries.
1. Remove close up plug on top of the wall mounting box.
2. Install photocell and wire as per diagram.
3. Use photocell rated for your supply voltage.
“COM”
PHOTOCELL
WP2FC
LIGHT
FIXTURE
BLACK
WHITE
ACCESSORIES
Wire Guard:
GDWP3W
ON-OFF WIRING
Universal voltage driver permits operation at 120V to 277VAC,
50 or 60 Hz except fixtures factory ordered with a 120V swivel
photocell (/PCS) or 277V swivel photocell (/PCS2) or 480V
swivel photocell (/PCS4). Units ordered with (/480V) suffix are
480V.
1.
Connect the BLACK fixture lead to the (+) LINE supply lead.
2.
Connect the WHITE fixture lead to the (-) COMMON supply
lead.
3.
Connect the bare copper Ground wire from fixture to
supply ground.
0-10V DIMMABLE WIRING
For 0-10V Dimming, follow the wiring directions
1.
For Junction Box Mount, feed wires through silicone
wiring plug into the junction box.
2.
Connect the black fixture lead to the (+) LINE supply lead.
3.
Connect the white fixture lead to the (-) COMMON supply
lead.
4.
Connect the GROUND wire from fixture to supply ground.
Do NOT connect the GROUND of the dimming fixture to
the output.
5.
Connect the purple fixture lead to the (V+) DIM lead.
6.
Connect the gray fixture lead to the (V-) DIM lead.
7.
Cap the yellow fixture lead, if present. Do NOT connect.
