REMODELER & NEW CONSTRUCTION TRIM
2IN 10W ROUND & SQUARE INSTRUCTIONS
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: [email protected]
REMODELER MOUNTING
For round ceiling cut out 2-3/8” dia. For square ceiling use
the 2-3/8” sq cut out template from packaging material.
1. Install
Ceiling Collar
into opening. Secure Ceiling Collar
by pushing fingertabs down tightly over ceiling. Fig. (3)
Note: Ceiling Collar is intended for 5/8”-3/4” sheet rock
ceilings. For 1/2” ceiling applications, use 1/8” shim to secure
trim module.
2. Loosen the
Junction Box Screw
and open the
Junction
Box
(Fig.2). Attach
Supply Wires
into
Junction Box
and
connect to the fixture. See wiring section for details.
3. Push up and slide the
Junction Box
section into the
Ceiling Collar
. Be sure the
Spring Clips
are snapped in
and
Trim Ring
is flush and secure.
Ceiling
Fig: 3
Remodeler Unit
Fig: 4
Ceiling Collar
5/8” TYP
3/4”MAX
TROUBLESHOOTING
1. Check that the line voltage at the fixture is correct. Refer
to wiring directions.
2. Is the fixture grounded properly?
CLEANING & MAINTENANCE
CAUTION: Be sure fixture temperature is cool enough to
touch. Do not clean or maintain while fixture is energized.
1. Do not open fixture to clean the LED. Do not touch
the LED.
2. Do not touch reflector, lens or trim cone.
3. Do not clean any fixture surface with wood base cleaning
material such as paper towels or tissues.
WIRING
RISK OF FIRE
. Universal voltage driver permits operation
at 120V thru 277V, 50 or 60 Hz. Drop down supply wires
must be at least 9” long to allow fixture removal. For Non-
Dimming (on/off), Electronic Low Voltage (ELV) and Triac
Dimming follow the wiring directions in Fig. 6. For 0-10V
dimming, Fig. 7.
1. Connect GROUND wire from fixture to supply ground.
2. Connect black fixture lead to the (+) LINE supply lead.
3. Connect white fixture lead to the (-) COMMON supply lead.
Ceiling Collar
use wood
Shim (if
necessary)
WALLWASH MOUNTING
1. For the Wallwash Model, orient the fixture such that
the
Lens such that the thin section
is aimed in correct
orientation.
2. If necessary, rotate of the wall wash lens to orient in
certain direction.
Fig: 5
This side away
from wall
Wall Wash lens
Fig: 7
Fig: 6
