INSTALLATION INSTRUCTIONS
RAB DESIGN LIGHTING INC.
10/09/2018
1
RAY8S-LED
ELECTRICAL SHOCK HAZARD
READ, UNDERSTAND
, and
FOLLOW
these instructions
before installing the equipment.
WARNING
SAFETY
Proper grounding is required to ensure personal safety.
Fixture should be mounted in locations where unauthorized personnel will not readily subject it to tampering.
Do not use this equipment for anything other than its intended purpose.
Servicing this equipment should be performed by qualified service personnel.
Save these instructions.
INSTALLATION
1.
Attach the anchor bolts to the concrete with a bolt centred diameter of
3.62” and the thread should protrude at least 3” from the concrete.
2.
Insert a nut followed by a washer to each anchor bolts.
3.
Place base plate over the over the bolts.
4.
Install wire and tie bracket on the base plate to one of the anchor bolts.
5.
Loosely tighten the flat washers and the nuts onto the anchor bolts
6.
Level the base plate by adjusting the leveling nuts under the base plate.
Then tighten the upper nuts on top of the base plate.
7.
Place the conduit wires through the wire-tie in the wire-tie bracket, Do the
connection through the zip-tie and tighten the wire – tie to make sure the
wires are above the ground level.
8.
Make the wiring connection as per the Wiring diagram.
9.
Place the fixture above the base plate and tighten the four hex head socket
screws at the bottom of column.
WIRING
Check that the line voltage is correct.
Connect fixture
GROUND
(green) wire to power supply
GROUND
(green) wire.
Connect fixture
WHITE
wire to power supply
NEUTRAL
wire.
Connect fixture
BLACK
wire to power supply
LINE
wire
Disconnect the Electrical supply power at the service panel (fuse or circuit breaker box). Failure to do so could result in serious
injury or death. Only qualified electricians should install this fixture and the installation MUST conform to the Canadian
Electrical Code Part I and all local codes and ordinances. Ensure that only proper tools, materials, and equipment are used to
complete the installation.
Anchor Bolts
Base Casting
Riser
Concrete
Grade
