Instruction Manual The Fischer R13 page 13 of 33
11 Treatment Recommendation
11.1 Parameter Settings
Before you place your hands/feet into the water bath trays, or insert the axillary
electrodes with the wet sponge pads under your arms, turn on the device. The
main power switch is located on
the back panel of the main control
unit (pictured right). The display
now shows all treatment settings.
Adjust the current setting (which
is always shown in blue) by
pressing the
buttons < >
.
Pressing the
SET-button
will take
you to the next line and you can
change these settings (including
treatment time, direct or pulsed current, and automatic or manual polarity
switch).
There is no start button
. Once the main control unit has been turned on and
the current level has been set, you’re ready to begin treatment. Place your
hands/feet into the water bath trays. You should feel a mild tingly sensation. On
screen, you’ll notice the Active Treatment Display (ATD) generating a bar graph
as the current level slowly ramps up.
Treatment Duration [min:sec]
The initial factory setting for treatment
duration and current strength is “1 min”
and “1 mA” respectively. After your first
treatment, The Fischer
®
automatically
saves the last settings used.
Set the treatment duration in minutes.
If you have selected the manual polarity switch (E1 << E2 or E2 << E1), choose
a treatment duration of 10 to 15 minutes. If you chose the AUTO setting
(automatic polarity switch), select a treatment duration of 15 to 20 minutes. If the