14
/ 42
User Manual
Rev. 1.0 - 12/07/20
TEX52TFT
ELETTRONICA
Obtain a 7/8” 50 Ohm RF cable for the connection between the Antenna and the
device; the part that goes towards the device must be equipped with a 7/8” EIA
connector.
Connect the RF output of the transmitter to the antenna cable or to a dummy load
capable of dissipating the power generated by the amplifier. Initially adjust the
exciter to the minimum output power and turn it off.
Connect the amplifier's INTERLOCK OUT output to the specific INTERLOCK IN
input fitted as standard in all the exciters of R.V.R. Elettronica. If the device is
different, identify an equivalent output.
Connect the RF output to a dummy load of suitable value or to the antenna
GSM/LAN
R
L
ADJ
TOS
LI
NK
AE
S/
EB
U
SCA1/RDS
RFL FWD
EXT AGC
REMOTE
INTERLOCK IN
R.F. OUTPUT
50
Ω
+
24Vdc
LEFT/MONO
19KHz PILOT
OUT
ADJ
ADJ
10K
Ω
ADJ
RIGHT
PHASE
ADJ
600
Ω
600
Ω
R.F. TEST
max 20dBm
MAINS VOLTAGE
MAINS
FUSE
10K
Ω
CARRIER
FREQ. ADJ
MPX
SCA2
RS
232
SE
RV
ICE
/RDS
MO
DE
M
²
Figure 5.1:
connections with the amplifier
CAUTION: To avoid electric shocks and electrocution, never touch the RF
output connector when the equipment is powered up and with no load
connected.
Check that the
POWER
switch on the front panel of the
TEX52TFT
is in the “
OFF
”
position.
Connect the audio and RDS/SCA cables of your sources to the input connectors.
Note:
to ensure both the safety of the operators and correct operation of the
equipment, it is essential that the mains system is earthed and properly connected
to the equipment.
