ELETTRONICA
1
/ 32
User Manual
Rev. 1.0 - 01/02/22
/TLW-TFT-E-2HE, /TLW-TFT-E-3HE & /TLW-TFT-E-4HE
1. /TLW-TFT-E-2HE, /TLW-TFT-E-3HE &
/TLW-TFT-E-4HE Option
1.1 Preparation
1.1.1 Preliminary checks
Provide for the following (applicable to operating tests and putting into service):
√
Connection cable kit including:
• Ethernet cable (cable with RJ45 connector, not included) for connection to
ADSL router or LAN network;
or
• Crossover Ethernet cable (cable with RJ45 connector, not included) for direct
connection to PC.
1.1.2 Connection
• Connect the
LAN
output of
/TLW-TFT-E-2HE, /TLW-TFT-E-3HE & /TLW-TFT-
E-4HE
option to the appropriate input of your ADSL router or LAN network. If
the connecting device is different, identify an equivalent.
Note:
If you intend to connect it directly to a PC, it is necessary to use a
crossover ethernet cable. This is a basic prerequisite to ensure equipment correct
operation.
1.2 First Power-On and Set-Up
Perform this procedure upon first power-up and each time you make changes to
the configuration this component is integrated into.
Once all connections previously described are performed, the equipment is ready
for commissioning.
Follow the procedure below to open the
WUI
(Web User Interface):
1) Open your web browser on your PC, and connect to
http://192.168.0.244
address to connect to the
WUI
(if LAN IP address was previously modified, it
is necessary to use the new one). At this point the following page opens:
