8
/ 24
Manuale Utente
Rev. 1.0 - 20/02/12
RDMODWEB
ELETTRONICA
5. Installation and configuration procedure
This section provides a step-by-step description of device installation and
configuration procedure. Follow these procedures closely upon first power-on
and each time any change is made to general configuration, such as when a new
transmission station is added or the equipment is replaced.
Once the desired configuration has been set up, no more settings are required
for normal operation; at each power-up (even after an accidental shutdown), the
device defaults to the parameters set during the initial configuration procedure.
The topics covered in this section are discussed at greater length in the next
sections, with detailed descriptions of all hardware and firmware features and
capabilities. Please see the relevant sections for additional details.
5.1 Preparation
5.1.1 Preliminary checks
Unpack the
RDMODWEB
interface and immediately inspect it for transport damage.
Ensure that all connectors are in perfect condition.
Provide for the following (applicable to operating tests and putting into service):
√
Connection cable kit including:
• Mains supply, 230 VAC (-15% / +10%), with adequate ground connection;
• Cable for connection of the exciter telemetry signal;
• Ethernet cable (not included) for connection to an ADSL router or LAN
network;
or
• Crossover Ethernet cable (not included) for connection to an ADSL router or
LAN network.
5.1.2 Connections
1) Connect transmitter
I
2
C
output to
RDMODWEB
interface
I
2
C
input.
2) Connect the
RDMODWEB
interface
NETWORK
output to the relevant input
of its ADSL router or LAN network. If your connection equipment is different,
identify an equivalent output.
Содержание RDMODWEB
Страница 1: ...RDMODWEB USER MANUAL Manufactured by R V R ELETTRONICA S p A Italy ...
Страница 4: ...ii User Manual Rev 1 0 20 02 12 RDMODWEB ELETTRONICA This page was intentionally left blank ...
Страница 28: ...24 24 Manuale Utente Rev 1 0 20 02 12 RDMODWEB ELETTRONICA This page was intentionally left blank ...